Skip to the page
Call us (909) 757-1103

Guide ยท Ontario

How to fix a leaky shower faucet

Where the water appears decides the fix: showerhead, tub spout or handle. Most drips trace to a tired cartridge or seal, and swapping one takes a screwdriver, a puller and about an hour.

Updated

Shower valve cutaway in a wall: handle, cartridge, hot and cold feeds, showerhead arm.

Think of the shower valve as a gate. Over the years its rubber seals soften, its ceramic edges chip and its brass seat pits, and then the gate no longer shuts tight. Swap the spent part and the drip stops. Before you reach for tools, notice where the water emerges, because the showerhead, the tub spout and the handle each point at something different. Other fixtures sit in its neighbors under faucet, sink, shower and disposal help.

What can I learn from where it drips?

Water at the showerhead after you shut off implicates the cartridge or seat. Water pouring from the tub spout mid-shower implicates the diverter. A damp collar around the handle implicates a seal ring or the packing. A brown stain on the wall, or a wet ceiling in the room below, means the pipe or valve is leaking inside the structure and you need a plumber.

Shower layout marking four drip spots: showerhead joint, handle, tub spout, and the wall behind the valve.
Symptom Likely culprit
Showerhead dribbles after shutoff Tired cartridge, washer or seat
Tub spout dribbles after shutoff Same valve fault, or the spout itself
Spout pours while the shower runs Diverter has failed
Wet around the handle Seal ring, packing or a loose connection
Wet at the showerhead joint Washer tired or tape missing
Stain, drip or sag in wall or ceiling Leak behind the surface

Run a dry test. Shut the shower off, wait several minutes and watch. A brief dribble that quits is just water left in the pipe; a steady one is a seal giving up. Also see whether only the hot side or only the cold side drips, since that narrows the faulty part. Planning more than a faucet? Read plumbing for a bathroom remodel.

Which shower valve is behind my wall?

Count the handles. A pair, one hot and one cold, typically hides compression stems or twin cartridges. A single lever that rotates and pushes or pulls typically hides a cartridge, a ball joint or a pressure-balancing unit. Check the cover plate or handle for a brand name, and look under the cap for a stamped model number.

Replacement parts do not cross between makers. Where possible, carry the old cartridge to a supply store so the clerk can match it, because a near match will not seal. Pressure-balancing valves, common in newer houses, keep temperature steady when a toilet flushes elsewhere, and they carry a cartridge with a spool inside that ages the same way.

Sink and outdoor versions of this repair have their own write-up, fixing a leaky faucet.

How is a tired cartridge swapped out?

Stop the supply to the bathroom, or to the whole house if you have to, then let the shower run until it stops. Remove the handle and cover plate, lift out the clip or nut that keeps the cartridge in place, draw the cartridge out, lay it next to the new one and slide the replacement in the way the old one sat. Rebuild, and bring the water back gradually.

The sequence:

  1. Shut the bathroom's stop valve or the main, then leave the shower open to empty the line.
  2. Lay a rag over the drain so tiny screws cannot vanish.
  3. Lever up the handle's cap, remove the screw hidden under it and slide the handle off. Photograph each stage.
  4. Unscrew the cover plate to bare the valve.
  5. Remove the clip, nut or bonnet that holds the cartridge, noting its position.
  6. Pull the cartridge straight out. A stubborn one may need a cartridge puller sold for common brands.
  7. Fit the new cartridge the same way around, hot side where it was.
  8. Put back the clip, cover plate and handle, then restore water bit by bit and test both temperatures.

Change the O-rings and washers while the valve is open and rub a little plumber's grease on them. Go easy on the retaining nut. If a cartridge will not move, stop before it breaks off in the wall.

How do I deal with a leaking showerhead or tub spout?

Where a showerhead meets the pipe, a leak needs clean threads, plumber's tape wound in the thread direction and a fresh washer if the old one cracked. One dripping from its face wants descaled nozzles or replacement. If the spout leaks at the wall, a fresh washer or a new spout is the answer.

Ontario's 2025 water report shows hardness averaging 91 to 177 ppm depending on source, and scale clogs showerheads and roughens valve parts. A vinegar soak often loosens it and brings back an even spray. If scale keeps winning, look into stopping hard water scale.

A lift-knob diverter that lets water out of the spout during a shower has worn out. Screw-on spouts come off by turning, while slip-on spouts hide a set screw near the wall. Replacing the spout is often quicker and cheaper than rebuilding the diverter.

Is a dripping shower expensive?

It adds up, and a hot drip costs twice, once for the water and once for heating it. Federal guidance is blunt: the Department of Energy advises repairing leaky faucets promptly, and the EPA's drip-rate figures show how a slow drip balloons over twelve months. A cheap cartridge usually beats months of waste.

With hot water dripping, the heater setting matters too. Energy Saver guidance suggests 120 degrees Fahrenheit, which lowers scald risk in the shower as well.

If a drip arrives with a high bill, the page on high water bills lists other sources. Check the wall and ceiling around the shower for stains as well.

Which shower leaks need a plumber?

A plumber should step in when stains show near the shower, the stop valve is seized, the cartridge sticks or snaps, the valve body is crusted with corrosion or the drip returns even with a new cartridge. Hidden leaks can rot framing and encourage mold; a plumber opens the wall, mends the valve and tests it.

A sagging ceiling under the bathroom, water seeping through a light fixture or soggy drywall means closing the water and calling immediately. Ceiling water leaks and plumber for shower leaks cover those cases.

A whole-valve replacement cuts into the wall; faucet and valve prices are on what installing a faucet costs. If flow is also weak, low shower water pressure may be related.

Start from the quote page at Chaffey Pipe and Drain; the plumber who answers travels to your door. Before work, learn what the visit covers and have the price written.

Ask for a written plumber quote

Fill this in and we'll arrange a local plumber specialist to come and price the job.

Needed so the business can price the job properly.

We earn a referral fee from the plumber who takes your job. You pay us nothing.

Common questions

Why won't the shower stop dripping once it is off?

A spent cartridge, washer or seat lets water creep past a closed handle, and mineral scale on the seat can do the same. Change the cartridge first. If a new one still drips, suspect damage to the valve body, and that needs a plumber.

Does the wall have to be opened?

Often not. Most cartridge swaps happen from the front, through the cover plate. A leaking valve body or leaking pipes behind the wall do need the wall opened. Watch where the water appears, and get a plumber for any leak inside the wall.

How long is the cartridge job?

Set aside roughly an hour for a first attempt. A stuck cartridge, an unidentified brand or a missing bathroom shutoff adds time. If you must close the main, warn the household first and keep the shower open to drain before starting.

Which cartridge should I buy?

Check the handle or cover plate for the brand and model, or take the old cartridge shopping. Compare length, splines and shape. Delta, Moen and Kohler cartridges differ, and a single brand can have several. An exact match prevents leaks.

Is a shower drip an emergency?

Seldom, though a leak behind the wall can turn urgent. A steady spout drip wastes water and money, so fix it soon. A wet ceiling, a soft wall or a growing stain is different: stop the bathroom's water and call a plumber.

References