Which parts of the plumbing does an inspector look at?
Everything between the street connection and the drain outlet, plus gas lines, which fall under the gas piping and appliance rules. The visit typically covers the water inlet and shutoff, exposed supply lines, the water heater and relief valve, fixture connections, drain and vent pipes below the floor, gas lines to appliances, and any sign of leaks or old patches. The result is a plain list: sound, worn, unsafe.
Most of a manufactured home's plumbing hides in the floor system, behind the belly wrap and under the bathrooms. So a thorough visit adds a pressure check on the supply, a drain test by running every fixture, and a look beneath the home for sagging pipe, damp insulation and rust.
Gas appliances add a separate layer, because in California permit work is for contractors with a current California license on file, and gas is the clearest example.
Which agency has authority over manufactured home plumbing?
The state housing department (HCD) regulates alterations to mobilehomes and manufactured homes, including review and inspection of plumbing. A city's ordinary building permit may not be the one you need, and the agency covering a park can vary, so ask the park manager or HCD before work begins.
The department's alteration permit page explains that every alteration to a mobilehome or manufactured home needs an application, names the form HCD MH 415, and says HCD staff handle plan review and inspection. Forms and rules change over time, so confirm with HCD rather than trusting a page like this one.
If a project goes beyond a small repair, phone the department first and find out whether you pull the permit or the contractor does. Skipping that step is the usual way a repair becomes a problem at sale time.
What goes wrong most in older manufactured homes?
Leaks at supply fittings below the floor, cracked or sagging drains, wet or missing insulation, tired water heaters, poor venting and unpermitted past repairs top the list. Some older homes were plumbed with polybutylene, so it pays to find out what the supply lines are actually made of.
Light materials and cramped spaces make small errors expensive. A drain with the wrong slope holds water. A supply line chafing on a sharp edge fails years later. Hard freezes are rare here, but a bare spigot or a pipe in an open skirt can still suffer on a cold night. For the old plastic, read polybutylene pipe replacement.
Warning signs worth an inspection: stained or soft flooring near a bath, a musty closet, a water bill that jumps. Leaks are a well-known source of wasted household water, according to the EPA, and under a manufactured home one can run for months unnoticed.
Where does backflow protection fit in?
Backflow means water traveling backward, from a hose, sprinkler or appliance into the drinking supply. At a home the safeguards are modest: vacuum breakers on outdoor spigots, air gaps at appliances, and sometimes a backflow assembly where the water enters. An inspector should note which are present and whether they work.
The usual gap is a hose left sitting in a bucket, pool or sprayer tank while attached to a spigot with no vacuum breaker. If your park or lot has a testable assembly, the local water supplier decides the test schedule, and the park manager or provider can tell you. Commercial details sit in commercial backflow testing and how testing is done.
What should a buyer check before closing on one?
Add a plumber's inspection to the general home inspection. Ask for repair and permit history, learn which agency covers the park, run every fixture, and look underneath. A seller who cannot name the plumbing work done is handing you a reason to look harder.
Walk-through list:
- Run hot and cold everywhere; flush each toilet twice.
- Hunt for stains, soft spots and musty smells near baths and the heater.
- Note the water heater's age, relief valve and discharge pipe.
- Peek under the home, if you can, for damp insulation and drooping drains.
- On gas, ask when it was last inspected. Do not check for gas with a lighter or match.
- Ask for permit or inspection paperwork.
SoCalGas cautions that smell alone is an unreliable gas detector. Suspect a gas leak? Go outside before anything else, then ring SoCalGas, 1-800-427-2200. Anyone who might be injured is a 911 call instead.
What is a fair DIY repair here, and what is not?
New faucets, fill valves and showerheads suit a handy owner. Rerouting drains or supply, replacing a water heater or opening gas lines is permit territory with HCD, and the state directs it to contractors holding a California license. Check first.
Swapping a fixture one-for-one may be treated differently from changing the pipes behind it. Confirm the rule for your particular job with the department. For more on bath and kitchen fixtures in these homes, see plumber for shower leak, which includes sink basics.
Freeze protection belongs in routine upkeep. Close and insulate the space under a skirted home, and wrap exposed spigots. Winterizing mobile home plumbing goes through it.
How do I get an inspection set up?
Give us the home's age, tell us whether it is in a park, and explain what you want examined and why, a purchase or a repair. Someone local gets sent. Look up the plumber's license on the state board website. Our phone line is staffed on weekdays, from 9am to 5pm.
Request a written report or quote listing what was inspected, what turned up, and what each repair involves. Phone prices are guesses, and a real number comes only from the written quote delivered post-visit. Kick things off at the quote page, and the Chaffey Pipe and Drain home page shows the rest. When permit work turns up, ask who talks to HCD or the local agency.
Common questions
Do buyers have to order a plumbing inspection?
Not as a rule, though lenders, parks and local requirements differ. Many buyers do it anyway, because the plumbing is hard to see under a manufactured home. Ask your lender and the park what they expect, and think about ordering one even if neither does.
Who inspects plumbing inside a park?
That depends on which agency covers the park, and the park manager or HCD can say which. HCD also reviews and inspects alterations to the homes themselves, so permit questions go to HCD or whichever agency it points you to.
Can an ordinary plumber work on a manufactured home?
For routine repairs, yes, and plenty of plumbers do. Alterations run through HCD's permit and inspection path rather than a city's, so the plumber should understand it. Find out whether they have worked in parks, who submits the permit and what happens at inspection.
What will an inspection cost me?
That depends on the home, the access and the scope, and no figure is printed here. Check whether a written report, camera work beneath the home or a pressure test is in the visit. Only the quote from whoever inspects your home fixes the price.
How often should I check the plumbing myself?
Once a season is sensible: under sinks, around the heater, at spigots, and beneath the home if you can reach it. Test the relief valve according to the maker's directions, watch the water bill for jumps and check insulation after storms. Small drips cost far less than ruined floors.